Are these velocity stacks standard ?

400_Rider · Post by **400_Rider** » Mon Sep 21, 2009 8:56 pm

Howdy guys

OK new bike (NC35) so am learning fast

I was looking in the Haynes manual this evening about how to remove the carbs, I cannot find the front two screws which hold the carbs into the inlet rubbers to save me life

Anyway while browsing through the haynes I saw pics of the velocity stacks and they are rubber in the picture yet mine are metal, heres a pic have a look :

I just wondered if this was standard on the NC35 or if this is a performance upgrade of some sort ?

Thanks

Post by **hunter** » Mon Sep 21, 2009 8:59 pm

nc30 are rubber nc35 are alloy.

400_Rider · Post by **400_Rider** » Mon Sep 21, 2009 9:17 pm

Cool thanks for that Hunter

Post by **Drunkn Munky** » Mon Sep 21, 2009 10:16 pm

The screws for the carb rubbers may have moved if someone wasnt carefull when they were last removed. There not easy to find if you dont know what your looking for so get a torch and have a poke around and your find them. If you think their hard to get to now just wait till you get a HRC syle carb tray

Are these velocity stacks standard ?

Are these velocity stacks standard ?

Re: Are these velocity stacks standard ?

Re: Are these velocity stacks standard ?

Re: Are these velocity stacks standard ?