vfr 400 nc30 fuel in the oil.....WHY? will not start

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
tudge-2009
Settled in member
Posts: 11
Joined: Mon Aug 24, 2009 5:24 pm
Bike owned: vfr nc30
Re: vfr 400 nc30 fuel in the oil.....WHY? will not start

Post by tudge-2009 »

:up: Thanks for all of your replys changed the oil cleaned the plugs started first time with smoke then cleared out.
Lope
Site Supporter
Site Supporter
Posts: 197
Joined: Thu May 22, 2008 1:37 pm
Re: vfr 400 nc30 fuel in the oil.....WHY? will not start

Post by Lope »

rc211v wrote:you can't see if it has been modified unless you open it up. best thing to do is to disconnect the fuel hose and see if fuel continuously flows even if the tap is in the OFF position.
Thats is incorrect. My fuel tap is modified, but it stops the flow when the tap is off.
The modified fuel tap always flows when the tap is on, while the standard tap requires the tap to be on, AND a vacuum at the pipe that leads down to the "auto fuel vacuum valve tube" on the engine.
rc211v wrote:you can't see if it has been modified unless you open it up
You only need to disconnect the tank from the bike, put it above a jug and turn the tap on to find out if its modified.

Stickshift: Quite right. Depends if its modified or not.

I agree with CMSMJ1. Fix the carbs or you'll always have some fuel trickling into your engine.

I actually had this problem to a certain degree with my old carbs and only fixed it *after* changing the oil. Perhaps I should change the oil again. Is the rule: If in doubt, change the oil? :) My filter is quite new, should I change it too or just the oil?
dx400r
Site Supporter
Site Supporter
Posts: 307
Joined: Mon Aug 25, 2008 1:41 pm
Re: vfr 400 nc30 fuel in the oil.....WHY? will not start

Post by dx400r »

its not immediately obvious without taking the fuel tap to pieces.

You can buy a repair kit for it. There was a split rubber diaphragm in mine that was letting the fuel flow anyway.

But please if the fuel in your oil and the resultant blue smoke hasnt injured your motor too badly any further starting attempts before you change that oil will finish it off.
rc211v
Settled in member
Posts: 23
Joined: Mon May 05, 2008 12:46 am
Location: South East Asia
Contact:
Re: vfr 400 nc30 fuel in the oil.....WHY? will not start

Post by rc211v »

Lope wrote:
rc211v wrote:you can't see if it has been modified unless you open it up. best thing to do is to disconnect the fuel hose and see if fuel continuously flows even if the tap is in the OFF position.
Thats is incorrect. My fuel tap is modified, but it stops the flow when the tap is off.
The modified fuel tap always flows when the tap is on, while the standard tap requires the tap to be on, AND a vacuum at the pipe that leads down to the "auto fuel vacuum valve tube" on the engine.
right! I forgot, I was talking about my knackered fuel tap. silly me.
Lope
Site Supporter
Site Supporter
Posts: 197
Joined: Thu May 22, 2008 1:37 pm
Re: vfr 400 nc30 fuel in the oil.....WHY? will not start

Post by Lope »

Ah, I see.
fastdruid
Regular Member
Posts: 893
Joined: Wed Apr 30, 2008 7:39 pm
Re: vfr 400 nc30 fuel in the oil.....WHY? will not start

Post by fastdruid »

Ok, first thing do *not* try and run it.

You need to drain the oil, remove and replace the oil filter, if you do not you run the risk of fscking up the engine.

Druid

Post Reply