NC30 using a lot of petrol!

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
tazbert
Settled in member
Posts: 12
Joined: Mon Aug 03, 2009 5:44 pm

NC30 using a lot of petrol!

Post by tazbert » Thu Aug 06, 2009 7:45 am

Hi Guys,

Thought I would try to pick your brains if I could!

My NC30 is using rather a lot of petrol at the moment.
Normally it will use (for example) 6 litres in 60 miles
(about 45 to the gallon if my maths is right).

It has been standing for a couple of months, and the last time
I took it out for a long run it used about 9 litres in
the same distance.

The only symptom was a slight 'wooliness', especially in
the midrange. No misfiring or roughness to indicate any
ignition problems.

I've checked the choke, that seems to be working ok,
do you have any suggestions for things to check when I
strip the carbs off?

Thanks

Andy

wullvfr
Site Supporter
Site Supporter
Posts: 1027
Joined: Wed Apr 30, 2008 8:40 pm
Bike owned: zx9r c1
Location: killin,scotland

Re: NC30 using a lot of petrol!

Post by wullvfr » Thu Aug 06, 2009 8:27 am

obviously it could be running rich!!!

any backfiring at all,does it bog down bad at all?what exhaust system are you running?

the best way to work out your mpg is making a note of how many miles you get before having to go into reserve.


wull
please,god,....give me the chance to prove that winning the lottery won't spoil me!!!

tazbert
Settled in member
Posts: 12
Joined: Mon Aug 03, 2009 5:44 pm

Re: NC30 using a lot of petrol!

Post by tazbert » Thu Aug 06, 2009 8:48 am

no backfiring etc, it seems to run almost normally.
just needs a bit more throttle than usual in the midrange (accelerating on the motorway etc)

engine is standard, apart from an F1 jet kit (bought from here a few years ago) ;o)
and the intake opened up a little at the front of the frame (under the steering head).

hth

thanks

andy

User avatar
Cammo
Site Supporter
Site Supporter
Posts: 4505
Joined: Thu May 01, 2008 12:35 am
Bike owned: NC30
Location: Melbourne, Australia

Re: NC30 using a lot of petrol!

Post by Cammo » Thu Aug 06, 2009 8:50 am

tazbert wrote: do you have any suggestions for things to check when I
strip the carbs off?

Yo Taz, best bet is that some of the holes in pilot jets, and main jets will be blocked. This will cause it to use more fuel as you'll need to use more throttle to make up for dodgy carb.

Open the carbs up and check all these, blowing them out to make sure they're not blocked. Fuel residue will block up stuff before you can even say 'I can't be arsed taking the carbs off and cleaning them'.... It's not a hard job if you follow the haynes, you'll get quicker at it every time.

I clean out my racebike carbs between track time as fuel gum blocks bits up very easily. 2 months of sitting will do it, especially in warmer months when fuel evaporates more quickly.
"It's just a ride" Bill Hicks

tazbert
Settled in member
Posts: 12
Joined: Mon Aug 03, 2009 5:44 pm

Re: NC30 using a lot of petrol!

Post by tazbert » Thu Aug 06, 2009 9:14 am

Thanks for that!

I was thinking if a jet was blocked it would:

a) be running rough as a cylinder was not getting the same fuel as the others and

b) be using less petrol!

will get the carbs off some time, bought some extra long screwdrivers the other day
to help get those ^%&^$£&* carb rubbers undone...

Thanks

Andy

User avatar
Cammo
Site Supporter
Site Supporter
Posts: 4505
Joined: Thu May 01, 2008 12:35 am
Bike owned: NC30
Location: Melbourne, Australia

Re: NC30 using a lot of petrol!

Post by Cammo » Thu Aug 06, 2009 11:54 am

tazbert wrote:Thanks for that!

I was thinking if a jet was blocked it would:

a) be running rough as a cylinder was not getting the same fuel as the others and

b) be using less petrol!
No. You'll be using more throttle to get the same sort of performance as standard. More throttle equals more fuel from the carbs that are working, regardless of what isn't working.

Get those long screwdrivers to work!
"It's just a ride" Bill Hicks

tazbert
Settled in member
Posts: 12
Joined: Mon Aug 03, 2009 5:44 pm

Re: NC30 using a lot of petrol!

Post by tazbert » Thu Aug 06, 2009 2:21 pm

Stickshift wrote:

Get those long screwdrivers to work!
yup, just got some 450mm ones from screwfix.
nearly lost an arm last time i tried to get to those carb rubbers!

cheers

andy

Waza4
Settled in member
Posts: 176
Joined: Fri May 02, 2008 1:49 pm
Location: Devon

Re: NC30 using a lot of petrol!

Post by Waza4 » Thu Aug 06, 2009 5:18 pm

Check the choke linkage isn't sticking as well.

Post Reply