nc23 exhaust from oil level hole!And rattle

wig · Post by **wig** » Tue Jul 07, 2009 7:20 pm

After a night out doign roundabout to get my knee down, i have started to get a rattle from my engine, also if i open the oil hole where the dip stick is, the exhast fumes come out of there.
number one exhaust does not get hot unless the engine is ragged, and when i compression test it, the compression was soemtimes there sometimes not.
when reving the engien the exhasut from oil hole problem dissapears.
gonna take it to bit in a minute with my misses!

Post by **CMSMJ1** » Tue Jul 07, 2009 9:11 pm

I kind of get what you are saying there...

It either has compression or it doesn't/ If you open the oil filler adn rev it..you should get oil splurging out I reckon..

Exhaust in the bottom of the engine means it is not working right so gas past the piston rings. You need to check it out matey..and get a trackday booked as there is nothing lamer than surfing roundabouts..lol

wig · Post by **wig** » Tue Jul 07, 2009 9:17 pm

if you pay for the track fees then I iwll go to a track day, until then im learning, and there is something gayer - street fighters.lol

it is def exhaust comming from the engine oil hole.
i have the top of and now have to work out how to get to the pistons.

wig · Post by **wig** » Thu Jul 09, 2009 5:57 pm

took engine apart, all the pistons are fine. lots of black chunks of soot on the tops of each of them.
all the rings are ok on each piston, there is some small brown staining above the oil ring and under the the two main rings on each piston.
it reminded me of my 2stroke days seeing all the soot. is this normal in a 2 stroke?
I could still see honing marks on each of the bores.
It was definately exhaust that was comming from the oil fil hole, just can work out where it was comming from.

wig · Post by **wig** » Sat Jul 11, 2009 9:05 pm

I have replaced the engine.
should have done it a long time ago, the replacement feels so smooth.
If anyone is after some spares let me know, I will take the old one apart if its not too much work.

drifterwannab · Post by **drifterwannab** » Sat Jul 11, 2009 11:38 pm

wig wrote:I have replaced the engine.
should have done it a long time ago, the replacement feels so smooth.
If anyone is after some spares let me know, I will take the old one apart if its not too much work.

how much for th gear box? And rhs engine casing

wig · Post by **wig** » Sat Jul 11, 2009 11:56 pm

send me an offer, or swap for something, rh casing looks like bike has gone down, but has no leaks just scuffs.
how far are you from oxford?

nc23 exhaust from oil level hole!And rattle

nc23 exhaust from oil level hole!And rattle

Re: nc23 exhaust from oil level hole!And rattle

Re: nc23 exhaust from oil level hole!And rattle

Re: nc23 exhaust from oil level hole!And rattle

Re: nc23 exhaust from oil level hole!And rattle

Re: nc23 exhaust from oil level hole!And rattle

Re: nc23 exhaust from oil level hole!And rattle