nc23 running odd???
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
- Settled in member
- Posts: 34
- Joined: Sat Nov 29, 2008 6:51 pm
- Location: Carterton, Oxfordshire
nc23 running odd???
hi all,
im having some problems with my bike i was riding along it started to die on me so i look down n its done 140miles since i filled it so i turn it to the reserve, it picks up again then within 1 minute the engine changes sound n i start getting vibration all over, so i pull over and as i stop the bike dies??
since then i've filled her up with bp ultimate, riden home 15miles, n the bike pulls fine, took it to the redline no trouble, but the noise is still there. the noise is a deeper tone, and it sounds lumpier more like a v twin at lower revs.
ive checked all the spark plugs n im getting sparks from all, had a play with the kill switch, the oil is fine, air filter is new, n ive sprayed some carb cleaner in the trumpets.
im at a loss
some plz help
cheers gaz
im having some problems with my bike i was riding along it started to die on me so i look down n its done 140miles since i filled it so i turn it to the reserve, it picks up again then within 1 minute the engine changes sound n i start getting vibration all over, so i pull over and as i stop the bike dies??
since then i've filled her up with bp ultimate, riden home 15miles, n the bike pulls fine, took it to the redline no trouble, but the noise is still there. the noise is a deeper tone, and it sounds lumpier more like a v twin at lower revs.
ive checked all the spark plugs n im getting sparks from all, had a play with the kill switch, the oil is fine, air filter is new, n ive sprayed some carb cleaner in the trumpets.
im at a loss
some plz help

cheers gaz
- w00dzy
- Site Supporter
- Posts: 514
- Joined: Sun Oct 12, 2008 10:44 pm
- Bike owned: Aprilia RSVR Mille
- Location: Hampshire
Re: nc23 running odd???
hello mate, first time I ran out of petrol I thought that something bad was happening! managed to switch it just in time while riding..
What your talking about does sound like fuel starvation (im no expert just a long shot) have you tried putting it back off the reserve to see if it works ok then?
What your talking about does sound like fuel starvation (im no expert just a long shot) have you tried putting it back off the reserve to see if it works ok then?
-
- Settled in member
- Posts: 34
- Joined: Sat Nov 29, 2008 6:51 pm
- Location: Carterton, Oxfordshire
Re: nc23 running odd???
i just tried that, no change. is that possible as its now got a full tank n its done 15 miles since i filled it up
i was thinking carb balancing, or checking that the jets were clear, or checking compresion, but i dont no im clutching at straws?
anyone? cheers gaz
i was thinking carb balancing, or checking that the jets were clear, or checking compresion, but i dont no im clutching at straws?
anyone? cheers gaz
- CMSMJ1
- Moderators
- Posts: 7161
- Joined: Thu May 01, 2008 9:42 am
- Bike owned: NC30-No9
- Location: Chesterfield, United Kingdom
Re: nc23 running odd???
Hows your oil looking??
I would be sightly worried to b honest and would be dropping the oil to make sure there were no bits of crank shell in it..or amything other than nice oily oil.
Any obvious metallic sheen, brass bits or the like and you are buggered. Get it droped into a clean container so you can have a good look at it.
This is worst case scenario time but hey - probably not gonna be your fuelling as you filled it up and it works..
Mate of mine broke his SV650.. clattering and clunking tractor noises and it would still rev....until it just plain died and seized solid.

I would be sightly worried to b honest and would be dropping the oil to make sure there were no bits of crank shell in it..or amything other than nice oily oil.

Any obvious metallic sheen, brass bits or the like and you are buggered. Get it droped into a clean container so you can have a good look at it.

This is worst case scenario time but hey - probably not gonna be your fuelling as you filled it up and it works..
Mate of mine broke his SV650.. clattering and clunking tractor noises and it would still rev....until it just plain died and seized solid.

IMPERATOR REX ANGLORUM
The V4 is the law..
NC30 - No9 - my old mate
The V4 is the law..
NC30 - No9 - my old mate
-
- Site Supporter
- Posts: 1027
- Joined: Wed Apr 30, 2008 8:40 pm
- Bike owned: zx9r c1
- Location: killin,scotland
Re: nc23 running odd???
when you get excessive vibration it is usually related to running on 3 or even 2 cylinders.you say you have checked the sparks but what about fuel???is fuel getting to all 4 cylinders?
next time you start the bike check and make sure all 4 downpipes are heating up and hot,if any are clearly colder than the others then you know its only firing on the hot ones.
electrical problems can sometimes be intermittent so the plugs may spark well when you checked them nut later on whilst out on the bike it may be a different story.
william
next time you start the bike check and make sure all 4 downpipes are heating up and hot,if any are clearly colder than the others then you know its only firing on the hot ones.
electrical problems can sometimes be intermittent so the plugs may spark well when you checked them nut later on whilst out on the bike it may be a different story.
william
please,god,....give me the chance to prove that winning the lottery won't spoil me!!!
-
- Settled in member
- Posts: 34
- Joined: Sat Nov 29, 2008 6:51 pm
- Location: Carterton, Oxfordshire
Re: nc23 running odd???
all 4 exhausts r heating up nicely, so i'd assume that means they're all getting fuel.
today i took the bike to my bike club n hooked it up to one of those manometers i think thats wot its called( the compression gauge thing) anyway i checked the carb syncronization, n it was quite badly off so i sorted that out, but it still had the same vibe n noise but it was less peaky.
so i decided while it was in bits i would clean out the carbs so got them off n cleaned out the float chambers, n the jets etc.. with carb cleaner n compressed air n put them bk together.
then i found a frayed trottle cable so i cant put it bk to gether n test it till i get a new one
so any more ideas while shes in bit?
cheers gaz
today i took the bike to my bike club n hooked it up to one of those manometers i think thats wot its called( the compression gauge thing) anyway i checked the carb syncronization, n it was quite badly off so i sorted that out, but it still had the same vibe n noise but it was less peaky.
so i decided while it was in bits i would clean out the carbs so got them off n cleaned out the float chambers, n the jets etc.. with carb cleaner n compressed air n put them bk together.
then i found a frayed trottle cable so i cant put it bk to gether n test it till i get a new one

so any more ideas while shes in bit?
cheers gaz
- lloydiecbr
- Site Supporter
- Posts: 271
- Joined: Fri Dec 26, 2008 11:11 pm
- Bike owned: VTR1000
- Location: coventry
Re: nc23 running odd???
change your oil and filter .check spark plug gaps .
-
- Settled in member
- Posts: 137
- Joined: Fri Mar 20, 2009 9:10 pm
Re: nc23 running odd???
hows your findings?
i have 2 spare engines.
I got them a while back.
let me know how u get on.

i have 2 spare engines.
I got them a while back.
let me know how u get on.

-
- Settled in member
- Posts: 34
- Joined: Sat Nov 29, 2008 6:51 pm
- Location: Carterton, Oxfordshire
Re: nc23 running odd???
its still in pieces at the moment, im still waiting on the throttle cable. i was kinda hoping it would have turned up by now, i'll let you know how it goes, n if i need any bits thanks.
i did do some work while i have it in pieces though, i took the mono shock and swing arm linkage out, cleaned them all n re-greased them.
i did do some work while i have it in pieces though, i took the mono shock and swing arm linkage out, cleaned them all n re-greased them.
-
- Settled in member
- Posts: 34
- Joined: Sat Nov 29, 2008 6:51 pm
- Location: Carterton, Oxfordshire
Re: nc23 running odd???
hi,
i put it back together today, i think i've fixed it i'll find out tomoz as i've got to ride up to nottingham, although i think my headers may be on there way out more god damn expence.
hopefully i'll make it without any problems i think i'll pack some tools just incase.
gaz
i put it back together today, i think i've fixed it i'll find out tomoz as i've got to ride up to nottingham, although i think my headers may be on there way out more god damn expence.
hopefully i'll make it without any problems i think i'll pack some tools just incase.
gaz