Head race bearings (Tapered)

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
User avatar
B4k88r
Settled in member
Posts: 8
Joined: Tue Aug 13, 2019 12:50 pm
Bike owned: VFR 400 VFR 750
Head race bearings (Tapered)

Post by B4k88r »

OK I have replaced the above with new tapered bearings

searching threads I have followed the advice below but not sure of the top steering nut torque settings - is it 140 nm as per the book

previous thread

I'll say it again, DO NOT TORQUE TAPER HEAD RACE BEARINGS! Just nip them up to take out the play, any kind of torque will crush them. The torque settings in the manual are for OE ball race bearings.
User avatar
B4k88r
Settled in member
Posts: 8
Joined: Tue Aug 13, 2019 12:50 pm
Bike owned: VFR 400 VFR 750
Re: Head race bearings (Tapered)

Post by B4k88r »

Anyone? As riding it around Thruxton in Tuesday 😁
Mark
richyrd5
Regular Member
Posts: 743
Joined: Fri Feb 21, 2014 1:31 pm
Re: Head race bearings (Tapered)

Post by richyrd5 »

As stated bud,dont torque tapered bearings,take the play out of them,tighten until the steering is smooth then lock the adjusting nut with top nut...
User avatar
B4k88r
Settled in member
Posts: 8
Joined: Tue Aug 13, 2019 12:50 pm
Bike owned: VFR 400 VFR 750
Re: Head race bearings (Tapered)

Post by B4k88r »

Yes I have done all that. It’s the top but I’m not sure about. Do you torque that to 140 nb
billgrundies
Settled in member
Posts: 46
Joined: Sun May 04, 2014 8:41 pm
Re: Head race bearings (Tapered)

Post by billgrundies »

23 to 25nm is enough.
User avatar
B4k88r
Settled in member
Posts: 8
Joined: Tue Aug 13, 2019 12:50 pm
Bike owned: VFR 400 VFR 750
Re: Head race bearings (Tapered)

Post by B4k88r »

Thanks
richyrd5
Regular Member
Posts: 743
Joined: Fri Feb 21, 2014 1:31 pm
Re: Head race bearings (Tapered)

Post by richyrd5 »

Just tight enough to lock it off but not turn the adjuster,then use lock washer tabs to lock both...

Post Reply