Project RVF stocker...ish

This section is reserved for members on the SITE SUPPORTERS group only. Each supporter can post pics of their bikes for all to view. Standard members can read and reply, but the post author has full control over his thread and can edit, delete & lock at will
Post Reply
User avatar
Tim400GB
Site Supporter
Site Supporter
Posts: 753
Joined: Mon Jan 04, 2010 7:24 pm
Bike owned: 1 x NC30, 2 x NC32.5,
Location: SE Greater London
Re: Project RVF stocker...ish

Post by Tim400GB »

So yeah, leaking in a few places from around the rim :x

Image
Top
ArizonaRVF
Settled in member
Posts: 29
Joined: Sat Jan 26, 2019 1:09 pm
Bike owned: 1994 RVF400R
Location: Desert Southwest USA
Re: Project RVF stocker...ish

Post by ArizonaRVF »

Well, ain't that a @#$%& Just when you think you have everything wrapped, Murphy shows up to test your patience.
Top
User avatar
Tim400GB
Site Supporter
Site Supporter
Posts: 753
Joined: Mon Jan 04, 2010 7:24 pm
Bike owned: 1 x NC30, 2 x NC32.5,
Location: SE Greater London
Re: Project RVF stocker...ish

Post by Tim400GB »

Well I didn't go for 40 but did put 35psi in the rear wheel and went for a careful trot to get its mot.
Which happened with a pass, bike felt pretty good, nice a smooth, chain needed a slight tighten but fingers crossed that's all.

Image

Ill check the rear pressure again later to see if the tyres seated after the run.
Top
ArizonaRVF
Settled in member
Posts: 29
Joined: Sat Jan 26, 2019 1:09 pm
Bike owned: 1994 RVF400R
Location: Desert Southwest USA
Re: Project RVF stocker...ish

Post by ArizonaRVF »

Congrats on the MOT, that's a mighty nice machine you have there. The best thing is, you brought it back with your own two hands.
Top
Post Reply

Return to “Members Bikes & Rides”