NC35 quickshifter
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
- Settled in member
- Reactions:
- Posts: 66
- Joined: Thu Jun 30, 2016 2:19 am
- Bike owned: RVF400
- Location: Australia, NSW
Re: NC35 quickshifter
Did you use a bike specific wiring kit for the iqse2? Looks like a very good sensor + stand alone module however cant find a kit that Healtech provides for the rvf400.violetpop wrote:Just wired up a Healtech iqse2 and set to 55ms, tested it at the track last week and it was perfect.
Does it connect to the ignition coils?
- Variablevalves suck
- Site Supporter
- Reactions:
- Posts: 1922
- Joined: Sat Jan 24, 2009 10:52 am
- Bike owned: GSXR Carb o'ring kits supplied
- Location: Stoke-on-trent
Re: NC35 quickshifter
The factory pro spring kits work well on the gsxr, no reason they wont work on the nc, although the Honda box does change like its made of stone compared to the Suzi box.
-
- Settled in member
- Reactions:
- Posts: 81
- Joined: Thu Mar 20, 2014 9:05 pm
Re: NC35 quickshifter
Sorry to revive this thread, however I'm keen to know about which wiring kit was used?jedidude04 wrote:Did you use a bike specific wiring kit for the iqse2? Looks like a very good sensor + stand alone module however cant find a kit that Healtech provides for the rvf400.violetpop wrote:Just wired up a Healtech iqse2 and set to 55ms, tested it at the track last week and it was perfect.
Does it connect to the ignition coils?
-
- Settled in member
- Reactions:
- Posts: 81
- Joined: Thu Mar 20, 2014 9:05 pm
Re: NC35 quickshifter
Nobody has used this quickshifter and can shed some light?
-
- Senior Member
- Reactions:
- Posts: 1894
- Joined: Mon Sep 20, 2010 11:55 pm
- Bike owned: VFR400
- Location: Blue Mountain NSW Australia
Re: NC35 quickshifter
You could try Healtech tech support. Healtech claims the iqse2 setup is for CDI and not TCI which is fitted to the NC30/35. If Healtech are unwilling to help you will be forced to buy the iqse-1 module and make your own loom or find someone who can.
-
- Settled in member
- Reactions:
- Posts: 66
- Joined: Thu Jun 30, 2016 2:19 am
- Bike owned: RVF400
- Location: Australia, NSW
Re: NC35 quickshifter
I ended up getting an ignitech cdi + quickshifter. Had to wire the sensor to the cdi and then attach it to earth (cut off taillight earth and crimped that).
Works really well and is actually a really smooth sensor set at 60ms
Holy smokes revival lol
Works really well and is actually a really smooth sensor set at 60ms
Holy smokes revival lol