Top front rocker cover nc30

[redmazda]

Hi all I've been on about getting this sorted for a couple of weeks not sure if anybody on her live local to me and would help me get it done I would be grateful as I'm only learning I want to fit a new gasket I got the parts here from CSM also four grommets for the bolts on top and at the same time replace spark plugs can anybody see by these photos if the top rad needs to come off to do this job

[jedidude04]

Alot easier to remove the top rad or swing it out of the way, then its just undo the the 4 bolts and replace the gasket + grommets. It's a good time to flush the cooling system :).

If you try to remove the spark plugs without the rad out of the way you're gonna have a bad time lol, may need universal joint to get the socket in the wells.

Are you sure you need to be replacing the gaskets? Personally if it wasn't leaking i'd keep it for spares later down the road.

[redmazda]

Yeah think I need to do gasket as I think that is leaking slightly and I know one grommet is also so may as we'll do them and soark plugs and oil change same time

[richyrd5]

I'll come up on weekend to do it for ya Darran ok bud..get the kettle on

[redmazda]

Rich it's on lol I'll get tank and airbox and bits off ready

[redmazda]

Thanks rich great help going for spin out on it tom fingers crossed thanks again

[richyrd5]

Your welcome bud..hope all went good

[redmazda]

Hi rich only got around to useing the bike this morning just rode 13 miles into work I just checked her over no leaks that's nice

[richyrd5]

Excellent news...glad all was good..give good clean to clock connections and earth on rev counter..all should be good then ..

[redmazda]

Thanks rich will do this morning this weather is wicked to get on them how's yours going send me a few pictures rich