NC30 wont turn on?
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
Stockko
- Settled in member
- Posts: 28
- Joined: Sat Nov 07, 2015 7:29 pm
NC30 wont turn on?
When I turn the key the bike won't turn on, no lights, nothing...
Fuses & battery are good also checked the wiring from the ignition leading up to the battery which seems fine.
Any ideas on what could be causing this?
Fuses & battery are good also checked the wiring from the ignition leading up to the battery which seems fine.
Any ideas on what could be causing this?
-
Ozzibiker
- Settled in member
- Posts: 19
- Joined: Tue May 20, 2014 5:33 am
- Bike owned: VTR250 / VFR400
- Location: Tokyo, Japan
Re: NC30 wont turn on?
If nothing is working, then the problem must be early in the circuit. If not the battery or fuses, then most likely the ignition switch.
The fuse box is after the ignition, so if power is getting to the fuse box, it's not the ignition. Possibly a connector after the box.
You'll have to get a multimeter and circuit diagram and check what wires have power.
Sent from my Nexus 7 using Tapatalk
The fuse box is after the ignition, so if power is getting to the fuse box, it's not the ignition. Possibly a connector after the box.
You'll have to get a multimeter and circuit diagram and check what wires have power.
Sent from my Nexus 7 using Tapatalk
-
magg
- Senior Member
- Posts: 1916
- Joined: Mon Sep 20, 2010 11:55 pm
- Bike owned: VFR400
- Location: Blue Mountain NSW Australia
Re: NC30 wont turn on?
You might check the fuse in the starter solenoid.