Right come on guys need help

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
mattydrvf
Settled in member
Posts: 112
Joined: Wed Apr 22, 2009 10:38 pm
Bike owned: Rvf baby
Location: kent
Right come on guys need help

Post by mattydrvf »

Hi peeps, finally got my rvf back together after getting all the carbs/jets etc cleaned. Fully charged battery but cant get the bugger to start. Is it usual to have problems after draining all the petrol out of the system. Will it just need time and turning over
User avatar
CMSMJ1
Moderators
Moderators
Posts: 7153
Joined: Thu May 01, 2008 9:42 am
Bike owned: NC30-No9
Location: Chesterfield, United Kingdom
Re: Right come on guys need help

Post by CMSMJ1 »

new plugs

or get the old out, get them dried over a flame - on your hob, not a dirty lighter!

Be sure you have the technique dialled....fuck all or 1% throttle and a bit of choke...few seconds, stop....few seconds, stop.

It is ont hard - they just drown the plugs nice and easy
IMPERATOR REX ANGLORUM

The V4 is the law..

NC30 - No9 - my old mate
mattydrvf
Settled in member
Posts: 112
Joined: Wed Apr 22, 2009 10:38 pm
Bike owned: Rvf baby
Location: kent
Re: Right come on guys need help

Post by mattydrvf »

So me sitting there with my finger on the button for ten mins probably didnt help. I didnt get the usual petrol smell you get when you flodd the engine so im not sure the petrol was actually getting through.
User avatar
Drunkn Munky
Site Supporter
Site Supporter
Posts: 6313
Joined: Thu May 01, 2008 9:37 am
Bike owned: NC30 MC21 TZR FZR GSXR RG MITO
Location: Kent
Re: Right come on guys need help

Post by Drunkn Munky »

Vac pipe connected to the tap?
User avatar
micpec
Site Supporter
Site Supporter
Posts: 1298
Joined: Sat May 03, 2008 9:11 pm
Bike owned: NC35’s, NC30 sold, MC34 many
Location: The Netherlands
Re: Right come on guys need help

Post by micpec »

killswitch?
"Action without Philosophy is a lethal weapon; Philosophy without action is worthless"
VtypeV4
Settled in member
Posts: 220
Joined: Sat Jun 27, 2009 10:57 pm
Bike owned: FJ1200 3CV, NC30, CX500
Re: Right come on guys need help

Post by VtypeV4 »

Check you have juice in the float bowls..
Kenthammer
NWAA Supporter
NWAA Supporter
Posts: 67
Joined: Sun Apr 12, 2015 9:30 am
Bike owned: 92 NC30 & 94 CBR900RRR
Location: Kent
Re: Right come on guys need help

Post by Kenthammer »

Not sure how you are doing this matty, but whenever I get to the stage of first fire up after everything has been apart, I use an aux fuel tank hung up above the bike and that way I can see what fuel amount is going into the carbs and can easily get to components normally buried under the tank.....as I said, no idea what your set up is mate, but if you are doing it with the tank on it can be bloody hard work to see any issues.

Also I leave the tank above the bike for a while after shutting off and can see if the level changes or not which is a good indicator to any leaks.
mattydrvf
Settled in member
Posts: 112
Joined: Wed Apr 22, 2009 10:38 pm
Bike owned: Rvf baby
Location: kent
Re: Right come on guys need help

Post by mattydrvf »

Cheers for the advise guys, got her going now and im over the moon, just needed a bit of time and a gentle touch :P

Post Reply