Hi all, so I got my fork sliders back today after them being powder coated, I got them home and checked them over, I noticed that some of the powder had got inside the slider tube, only dust particles but they have been heated so won't just wipe away, will this effect the forks? A stanchion with bush goes in and is not tight but I worry the bush with ware faster?
Thanks in advance
Powdercoat nc30 forks
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
damedichi
- Settled in member
- Posts: 22
- Joined: Fri Apr 11, 2014 2:38 pm
- Bike owned: KTM 990 Adv and NC29
- Location: Gosport/Hull
Re: Powdercoat nc30 forks
Try a bit of gasket remover, that'll get rid of your excess powdercoat. I used it to good effect when some parts of my frame were coated where it wouldn't have been. (Engine mounting points and some points where smaller bolts screw in)