NC29 Fork Pipe Seat

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
CBR400RR_Repsol
Settled in member
Posts: 41
Joined: Sun Feb 17, 2013 11:49 pm
NC29 Fork Pipe Seat

Post by CBR400RR_Repsol »

Hi all

So whilst stripping the forks I found that the bolt on the bottom of one of them didn't want to move :shock: . Tried everything and in the end had to drill the thing out :x

I was slightly out with my 'accuracy' and have taken a small out of the thread out of the bottom of the pipe seat where the bolt screws into... :whistle:

My question is - does this really matter? I have checked and the bolt from the other fork bolts up into the damaged pipe seat. I intend to get a new bolt and copper washer to replace the one I've drilled out.

So have I completely fooshed up or should it be OK? :pray:

Cheers
Kev
Top
richyrd5
Regular Member
Posts: 743
Joined: Fri Feb 21, 2014 1:31 pm
Re: NC29 Fork Pipe Seat

Post by richyrd5 »

If the bolt goes in ok and tightens up then no probs.make sure you clean/flush the swarf out of tube so no nastys floating about..
Top
Post Reply

Return to “Honda - Workshop”