Advice on removing decals off oem fairing
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
Johannes
- Settled in member
- Posts: 36
- Joined: Thu Jul 03, 2014 11:38 am
Advice on removing decals off oem fairing
Bought a set of fairings from a breaker for my NC24. They are Honda OEM units but in good nick except for a few scratches and I want to clean them up and respray them. However I need to get the OEM decals off the fairing panels. Any suggestions? I was thinking a heat gun suitably distant to damage the vinyl/plastic of the decals but not the fairings?
Any other experience/suggestions welcomed. Thanks.
Any other experience/suggestions welcomed. Thanks.
-
Drunkn Munky
- Site Supporter
- Posts: 6313
- Joined: Thu May 01, 2008 9:37 am
- Bike owned: NC30 MC21 TZR FZR GSXR RG MITO
- Location: Kent
Re: Advice on removing decals off oem fairing
Hair dryer a heat gun will get too hot if your not careful. You best check you can get replacement decals first though which I doubt you can.
-
Johannes
- Settled in member
- Posts: 36
- Joined: Thu Jul 03, 2014 11:38 am
Re: Advice on removing decals off oem fairing
Was going to rub down and respray in any event. I can get the majority of new decals made if they're not readily available.
Like I said these fairings are in good nick but too tatty to leave as is.
Like I said these fairings are in good nick but too tatty to leave as is.