Nc29 clutch question

Goulime · Post by **Goulime** » Tue Mar 11, 2014 1:44 pm

Hi all,
i've rebuilt my cbr clutch last sunday, and i found a very strange issue when i finished it....
i thought that evrything is ok but, the lifter seems not pushing the clutch.... i cannot test cause my carbs are at the workshop...
is it a normal thing ? maybe i have too much press springs???

any advice ?
thanks
Guillaume

Goulime · Post by **Goulime** » Thu Mar 13, 2014 9:33 pm

No one can help?
When we look at this schema, http://www.cmsnl.com/honda-cbr400rrl-nc ... ml#results
It's like n°14 never touch n°21

Thanks

dunkenb · Post by **dunkenb** » Fri Mar 28, 2014 10:04 am

Make sure all the clutch plates are seated properly some times the bottom ones can come out of line whe your putting the last ones in .

Goulime · Post by **Goulime** » Mon Mar 31, 2014 12:45 pm

Thanks for your reply, i've found my issues...
Last plate has a bigger inner diameter.... and my new clutch cable was too long....

everything is ok now!

Nc29 clutch question

Nc29 clutch question

Re: Nc29 clutch question

Re: Nc29 clutch question

Re: Nc29 clutch question