exhaust diameters
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
jrdwthomas
- Site Supporter
- Posts: 22
- Joined: Sat Aug 30, 2008 6:06 pm
- Location: Southampton
Re: exhaust diameters
Many moons ago i was an orange smurf!
-
Spike16
- Site Supporter
- Posts: 1670
- Joined: Tue Apr 29, 2008 8:56 pm
- Bike owned: NC30 Road, SV650 Race
- Location: Hampshire, Wichester
Re: exhaust diameters
dont worry, we all have a dark past we dont like draggin up :)
ok il look out for you on sunday, you'll se the nc in the car park, probably park up next to a bronze sv (my mates who working in the bike bit)
ok il look out for you on sunday, you'll se the nc in the car park, probably park up next to a bronze sv (my mates who working in the bike bit)
-
DAC
- Site Supporter
- Posts: 104
- Joined: Thu May 01, 2008 8:07 am
- Bike owned: 89 NC30
- Location: Netherthong
Re: exhaust diameters
Hi,
Sorry for the delay, no power at work this morning, just hired a generator & now back on line.
Measured outlet flange at 48.5mm, max 48.9 (suspect a bit oval). Length of stub is 41mm.
My two cans are both a tight push fit onto the half system and they have four expansion slots of about 30mm length.
Hope this info is useful,
Regards,
Dave.
Sorry for the delay, no power at work this morning, just hired a generator & now back on line.
Measured outlet flange at 48.5mm, max 48.9 (suspect a bit oval). Length of stub is 41mm.
My two cans are both a tight push fit onto the half system and they have four expansion slots of about 30mm length.
Hope this info is useful,
Regards,
Dave.
RWB NC30
-
V4Chris
- Settled in member
- Posts: 35
- Joined: Wed Apr 30, 2008 4:17 pm
- Location: Devon, UK
- Contact:
Re: exhaust diameters
Thanks for all the information, I sent the measurements off to a custom place and they should get one ready soon.
Depending on how it turns out would anyone else like one made like this?
Depending on how it turns out would anyone else like one made like this?