advice on rusty disc

jay20jay · Post by **jay20jay** » Fri Aug 09, 2013 1:19 pm

I would if I could but im rebuilding the bike so no can do trying the coke then will give them a go over with some wire wool
Thanks for replies

Post by **micpec** » Fri Aug 09, 2013 2:56 pm

If there is still plenty of "meat" on them, you might consider to find a local garage that have this...

jay20jay · Post by **jay20jay** » Fri Aug 09, 2013 3:37 pm

I shall have a look into this be good for the fronts if they can be done

Post by **Neosophist** » Fri Aug 09, 2013 3:54 pm

Ive ground discs down on the lathe many times, its mainly done to remove any prominent lipping on the edge of the disc, not for rust.

The rust will go away as soon as you use the brakes a bit. The discs are not cast iron so they wont be all rust just a high iron content.

jay20jay · Post by **jay20jay** » Fri Aug 09, 2013 4:19 pm

Done one side

vfrman · Post by **vfrman** » Fri Aug 09, 2013 4:38 pm

Looks nice, but that center part is going to corrode now....

jay20jay · Post by **jay20jay** » Fri Aug 09, 2013 4:44 pm

Na if the other side comes up I shall paint the centre

advice on rusty disc

Re: advice on rusty disc

Re: advice on rusty disc

Re: advice on rusty disc

Re: advice on rusty disc

Re: advice on rusty disc

Re: advice on rusty disc

Re: advice on rusty disc