Nc30 radiator question
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
jamie125
- Site Supporter
- Posts: 112
- Joined: Wed May 14, 2008 9:31 pm
- Location: Leighton Buzzard
Nc30 radiator question
Have just installed a Chinese bottom rad, the thread for the thermoswitch is too small for the switch, don't really want the Hassle of sending it back, so what are my options (if any), could I possibly run a tap through the thread or would that be a no no? Could I get hold a smaller switch? Any other opinions?
-
Haydn
- Settled in member
- Posts: 104
- Joined: Sun May 06, 2012 10:03 am
Re: Nc30 radiator question
How much smaller is it? Can you measure the switch and the thread in the rad? If there's enough metal on the boss I can't see why you can't drill it out and tap it, just put the hose pipe through it before fitting.
-
KennonNC29
- Settled in member
- Posts: 115
- Joined: Tue Feb 21, 2012 1:39 pm
- Bike owned: NC30
- Location: Oxford, Peterborough, new territories Hong Kong
Re: Nc30 radiator question
+1 on drilling and tapping it.
Kennon
Kennon
-
jamie125
- Site Supporter
- Posts: 112
- Joined: Wed May 14, 2008 9:31 pm
- Location: Leighton Buzzard
Re: Nc30 radiator question
Yeah tapped it out today, cheers for your input!