Drilling the carb bracket - HRC NC30 setup

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
lukemillar
Site Supporter
Site Supporter
Posts: 690
Joined: Thu Aug 26, 2010 11:43 pm
Bike owned: '89 NC30 Racebike #24
Location: Wellington, New Zealand
Drilling the carb bracket - HRC NC30 setup

Post by lukemillar »

Hey,

Just measuring these out based on the HRC manual and I just want to double check that the patten isn't regular. Looking at this page:

http://akhara.com/nc30/nc30hrccarb/index.html

and also at Cammo's carbs in his carb guide, all the holes seem regularly spaced, however, the diagram seems to have a larger offset on one side of the centre line to the other:
Image

I'm reading these as 18mm and 8mm respectively. I guess the ultimate questuon is... does it matter?

Cheers
Luke
Top
User avatar
CMSMJ1
Moderators
Moderators
Posts: 7161
Joined: Thu May 01, 2008 9:42 am
Bike owned: NC30-No9
Location: Chesterfield, United Kingdom
Re: Drilling the carb bracket - HRC NC30 setup

Post by CMSMJ1 »

I doubt it matters at all.

Get the fins out of the middle nicely though and as long as the tray doesn't flex too much it will be right
IMPERATOR REX ANGLORUM

The V4 is the law..

NC30 - No9 - my old mate
Top
User avatar
Yakama
Site Supporter
Site Supporter
Posts: 1369
Joined: Wed Apr 30, 2008 5:27 pm
Bike owned: NC23s, 29, 30s, MC16
Location: Oban
Re: Drilling the carb bracket - HRC NC30 setup

Post by Yakama »

Thought I'd update this as I have got an original manual that shows the dimensions more clearly:

Image
Top
Post Reply

Return to “Honda - Workshop”