Hi,
After a few long rides I've been noticing my bike stinks of eggs, after a little research I see that it's the battery making the smell with it being over charged. I've done a few tests this morning and all seems fine with the battery not going over 14.5v when at 5k RPM, around 13.3v at idle.
I'm just wondering whether I should replace the battery even though the tests suggest it's fine? As it could also be the regulator and I see the best replacement is the R6 regulator, is there any guides for this?
Thanks
NC30 Eggy Smell
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
starkey
- Site Supporter
- Posts: 14
- Joined: Tue Feb 14, 2012 5:09 pm
- Bike owned: NC30
-
iDemonix
- Site Supporter
- Posts: 651
- Joined: Tue Aug 24, 2010 10:26 pm
- Bike owned: '92 NC30
- Location: Banbury, Oxfordshire
Re: NC30 Eggy Smell
Only advice I can offer is for the reg/rec - no guides needed, it's a simple swap.
A roaring V4 is the summer soundtrack.
-
Morespeedvicar
- Site Supporter
- Posts: 837
- Joined: Thu May 01, 2008 1:37 am
- Bike owned: Fzr400, NC30, CB50J, SS50Z KLR
- Location: Grimsby
Re: NC30 Eggy Smell
I would think the battery is low on water, there sealed ish so your not supposed to top them up but you can if your very carefull, tho its prob easier and safer to buy a new one. Just makes sure all the connections are ok on the reg/rec, and keep an eye on it, maybe take bike out for half hour then test it again.
If its still metering out ok i'd leave it as is for now, but can deffo recomend the r6 reg, easy ish to do, theres loads a post on here, try a search. There not a exact plug and play swap, you have to change the plug to use a r6 reg but its easy with some patients, new spade connectors and a soldering iron.
Cheers
Ian
If its still metering out ok i'd leave it as is for now, but can deffo recomend the r6 reg, easy ish to do, theres loads a post on here, try a search. There not a exact plug and play swap, you have to change the plug to use a r6 reg but its easy with some patients, new spade connectors and a soldering iron.
Cheers
Ian
-
iDemonix
- Site Supporter
- Posts: 651
- Joined: Tue Aug 24, 2010 10:26 pm
- Bike owned: '92 NC30
- Location: Banbury, Oxfordshire
Re: NC30 Eggy Smell
I didn't think you had to change the plug?
In that case get a CBR125 reg/rec, that's definitely plug and play because I've got one. Been fine for the last 2 years.
In that case get a CBR125 reg/rec, that's definitely plug and play because I've got one. Been fine for the last 2 years.
A roaring V4 is the summer soundtrack.
-
starkey
- Site Supporter
- Posts: 14
- Joined: Tue Feb 14, 2012 5:09 pm
- Bike owned: NC30
Re: NC30 Eggy Smell
Bike died on me today, wouldn't power the dash and the bike wouldn't turn over although when checking the battery it was at 13.4v. Got some jump leads on the terminals and it started fine so I assume it is the battery I need to replace.
-
Cammo
- Site Supporter
- Posts: 4505
- Joined: Thu May 01, 2008 12:35 am
- Bike owned: NC30
- Location: Melbourne, Australia
Re: NC30 Eggy Smell
Sulpher smell always equals dead battery!
Once you've replaced the battery, best to check the generator and reg/rec, you don't wanna kill the new one.
Once you've replaced the battery, best to check the generator and reg/rec, you don't wanna kill the new one.
"It's just a ride" Bill Hicks
-
shaneo
- Settled in member
- Posts: 23
- Joined: Mon May 20, 2013 5:34 am
- Bike owned: ZX7r Tracky, RVF400
- Location: Melbourne, Australia
Re: NC30 Eggy Smell
i would also suggest unbolting the reg/rec and putting some CPU thermal paste between the reg/rec and the frame. will help a heap with heat dispertion.
-
starkey
- Site Supporter
- Posts: 14
- Joined: Tue Feb 14, 2012 5:09 pm
- Bike owned: NC30
Re: NC30 Eggy Smell
Replaced the battery, rode the bike for a week and I've come back from a ride today with it stinking of eggs again so I can only assume its the reg/rec overcharging it? Are the R6 regulators a straight swap, if not is there any problem with just replacing it with this: http://www.ebay.co.uk/itm/Honda-Rectifi ... 2ec8518ad8