HRC carb mesh

[28hodge]

I have never gotten round to placing a s/s mesh over my hrc open carbs, to be honest i had forgotten about it a bit until a re read an old post that i have bookmarked for another reason.

I've found this website and as always too many options has me confused.

I was going to go with the first mesh 10 type, think this will be ok?

http://www.themeshcompany.com/acatalog/ ... -size.html

[porndoguk]

Halford do some panel repair mesh in alloy its perfect for the job and only a couple of quid. Will find you the link

[porndoguk]

http://www.halfords.com/webapp/wcs/stor ... yId_165625

[28hodge]

Perfect,

Ta

[Drunkn Munky]

Didn't tim use that mesh from halfords and is went rusty? Kurt i have the SS mesh on mine pretty much the same as in the link you posted, its a bitch to cut and leave a nice edge but its solid and does the job well.

EDIT: Here you go, i finished mine off with some electrical tape to stop it shreading my fingers

[28hodge]

Well my local halfords are showing no stock of the mesh in the link Rick put up so i have ordered the first number 10 mesh in the first link.

Thanks guys

[porndoguk]

Didn't tim use that mesh from halfords and is went rusty? Kurt i have the SS mesh on mine pretty much the same as in the link you posted, its a bitch to cut and leave a nice edge but its solid and does the job well.

EDIT: Here you go, i finished mine off with some electrical tape to stop it shreading my fingers

Doubt it, the halfords stuff is alloy

Maybe he got the mesh from the ripspeed chav section lol

[Drunkn Munky]

Probably, he is a bit of a chav

Here you go
viewtopic.php?f=62&t=33406&start=90

And later on, rusty
viewtopic.php?f=62&t=33406&start=170

Weather he actually bought that stuff from halfords i dont know, im surprised he didn't machine one from a solid lump of alloy

[porndoguk]

Probably, he is a bit of a chav

Here you go
viewtopic.php?f=62&t=33406&start=90

And later on, rusty
viewtopic.php?f=62&t=33406&start=170

Weather he actually bought that stuff from halfords i dont know, im surprised he didn't machine one from a solid lump of alloy

Yeah thats not the halfords stuff, its a really thin and light aluminium mesh,

I had the pleasure of meeting Tim and team at santa pod yesterday, they did good they only finished 1st and have a nice trophy to show for it and a snaped cam chain which gave way after the quarter mile!

[Tim400GB]

Oi you bunch of cheeky so and so's

The mesh I got was from B&Q, wasnt cheap so I assumed it was stainless