Another 'spare' bike

[Tim400GB]

Don't think they're rvf, these cables are huge.
I'm not entirely sure of their origin, maybe they're off a hornet or something.

Got the carbs finished tonight, will get some pics up soon.

[Tim400GB]

Got some more capheads so I got the lower rad all buttoned and wired up. Just the hoses to do on that.


Have also built the carbs to HRC spec.

Heres the new drilled airbox , with the short stacks.


The NC24 'HRC style' half moon slides with 8ZG HRC needles + 0.5mm lift.



A few parts with a new coat of zinc


Rick Oliver HRC jet kit, #40PJs, #142.5MJ, new emulsion tubes and new bowl seals. Mixture screw set to (edited) 1.5 turns out.



And finally the rock catcher I made.


Plonked on the bike waiting for throttle and choke cables and clamps for the inlet rubbers.

[vfrman]

Nice! I would like to see more on that birdcage you made for the carbs...

[webby16]

iv been thinking about doing this to my carbs! well a spare set for the track! nc30 carbs with drilled airbox and short velocity stack with the nc24 slides! and like yours the hrc airtray! very nice!!!

[Tim400GB]

Nice! I would like to see more on that birdcage you made for the carbs...

Its just a cut down airbox (donated by Drunkn Munky, cheers buddy) with some mesh from B&Q.

[vfrman]

Well it looks classy from here.

[Drunkn Munky]

The rock catcher came out well, I'm off to get the dremel out

[Tim400GB]

Cheers chaps, I'm fairly happy with it.

[Cammo]

The mesh does look good.

What sized pilot jets are you using? I would recommend #40 and then set the mixture screw to 1.5 turns out.

[Tim400GB]

Sorry yeah that's a typo, got #40PJ's in there, have changed it now.

Cheers, the mixture screw setting was a guess. Will change them to 1.5 turns out.