Sams' cheap NC30 rebuild!

[vic-vtrvfr]

Cant remember the name, have their details saved somewhere.
I'll price them, if its stupid then i'll just go elsewhere.

[Sam-NI]

Forks rebuilt and rear Hub out. It was dry as a bone! No grease in sight. I also found a little rubber wedge in the swingarm. Possibly a side stand rubber. Not sure, will fire some Pics up after work!

Now only have to do valve clearances (which i've been putting off like mad) and a few other wee bits to tidy it up!

And put it all back together of course!

[vic-vtrvfr]

Cool.
I'm looking forward to seeing this finished.
But you're making me feel bad about the slow progress with my 2 now!!

[Sam-NI]

Just to make you feel bad Vic!

Panels re-lugged and test fitted



Rubbed down





Then stripped



Few new seals and bits





And Rebuilt



Whats that hiding in the swing arm?





Any ideas?

Gave it a good scrub





Panels are off to painters, have been filled and tidied up. There looking great. Trying to sort decals out soon!

[vic-vtrvfr]

Cheers for that chum!!!
In my defence, one of mine was a non runner & the other one has been built from spares!! Lol

But yours is looking great, good work, look forward to more pics

[Sam-NI]

Hope to spray up daft bits like the fan mount, screen brace and maybe yokes tomorrow evening. And maybe a bit more cleaning. Then might spend Friday night in the pub, so i'm hungover, and have an excuse not to do my valve clearances on Saturday.

[vic-vtrvfr]

Sounds like a plan!!
I'm hoping to get time on sat, replace exhaust gaskets on one & try to free clutch.
Then fit loom, carb rubbers, carbs to the other.
Samcos arrived yday, so should be able to test fit the rads

Must get a cuppa/pint sometime & a proper chat, only 10 mins away from each other!

[Sam-NI]

Yeh mate, i'm actually in Lisburn now. May be closer to you again. How are the samcos?

[vic-vtrvfr]

Samcos Seem spot on, had very little use
Lisburn is dead handy, just up the A1 & you're at mine!!

[VFRkieran]

Looking good mate ill be following this with interest, that bit of rubber looks like it could be a tank rubber, i found one wedged under the water pipe in the middle of the engine.