Help, quick nc21 hydraulic clutch pushrod question

Post by **royster81** » Fri Aug 10, 2012 10:16 pm

I've a vfr750 push rod I want cut shorter but I'm not 100% on the lenght

Is it 338mm ?

Post by **royster81** » Sat Aug 11, 2012 2:17 pm

Can anybody help please

Post by **Jamboy** » Sat Aug 11, 2012 9:55 pm

I've got a nc21 rod ready to do the conversion on my nc30 so if I remember in the tomorrow I'll get you the measurement.

Post by **mo haggs** » Sat Aug 11, 2012 10:15 pm

Jamboy wrote:I've got a nc21 rod ready to do the conversion on my nc30 so if I remember in the tomorrow I'll get you the measurement.

Post by **royster81** » Sun Aug 12, 2012 7:04 pm

mo haggs wrote:
Jamboy wrote:I've got a nc21 rod ready to do the conversion on my nc30 so if I remember in the tomorrow I'll get you the measurement.

Post by **Jamboy** » Sun Aug 12, 2012 7:06 pm

Give me 5 mins I'll be back

Post by **Jamboy** » Sun Aug 12, 2012 7:12 pm

Looks like 316mm hope that helps.

Post by **mo haggs** » Mon Aug 13, 2012 10:20 pm

Jamboy wrote:Looks like 316mm hope that helps.

the std nc30/35 rod is aprox 322-323 - the nc21 rod is longer to alow for the hydraulic slave cylinder.

somthing is amiss pal

Post by **Jamboy** » Mon Aug 13, 2012 10:51 pm

I'm glad you pick up on that, the twat on eBay sold me something else then. I had never checked it till now

Post by **mo haggs** » Mon Aug 13, 2012 11:20 pm

check it against your standard nc30 rod - the nc21 rod should be aprox 15mm longer.

i got a vfr750 rod and cut it down.