Hello all, anyone using one of these http://www.ebay.co.uk/itm/310275609475? ... 3471wt_922
with there nc29? Cheers
Headstock padock stand fit nc29?
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
oristt
- Settled in member
- Posts: 13
- Joined: Tue May 22, 2012 7:23 pm
- Bike owned: "NC29 BABY"
- Location: Devon
-
vr46
- Site Supporter
- Posts: 294
- Joined: Sun Jun 15, 2008 1:42 pm
- Bike owned: All sorts
- Location: CUMBRIA
Re: Headstock padock stand fit nc29?
As long as you obtain the correct pin then that one should be fine.
Skint Novice F400
-
oristt
- Settled in member
- Posts: 13
- Joined: Tue May 22, 2012 7:23 pm
- Bike owned: "NC29 BABY"
- Location: Devon
Re: Headstock padock stand fit nc29?
Would you happen to know the correct pin size? Cheers
-
vr46
- Site Supporter
- Posts: 294
- Joined: Sun Jun 15, 2008 1:42 pm
- Bike owned: All sorts
- Location: CUMBRIA
Re: Headstock padock stand fit nc29?
For my NC29: (would be best to double check your bike)
Yoke hole 24mm, I ordered a 23.8mm pin to be on the safe side as to make sure the fitting wasn't too tight. I bought my stand from Harris and the pin was made for me.
Yoke hole 24mm, I ordered a 23.8mm pin to be on the safe side as to make sure the fitting wasn't too tight. I bought my stand from Harris and the pin was made for me.
Skint Novice F400