Speedo not working.

Phil_Norwich · Post by **Phil_Norwich** » Wed Jun 06, 2012 9:48 pm

Hi there.

The speedo on my bike has stopped working. I've read that it could be the drive unit by the sprocket rather than the cable. How do you the cable to see if its faulty or not?

Thanks in advance.

Phil.

hannakournikova · Post by **hannakournikova** » Wed Jun 06, 2012 10:51 pm

Yea there is a nylon bush that attaches to the speedo drive at the sprocket end. It's pretty common for them to round off.
Disconnect the cable from the non sprocket end and I attached to and electric drill and pulled the trigger

Post by **Deviant400** » Wed Jun 06, 2012 11:01 pm

or just disconect the speedo cable both ends you should be able to turn the inner with your fingers easily , remove the speedo drive from the sproket cover and check the white drive bush that attaches to the sproket nut is not fooked
http://www.davidsilverspares.co.uk/part ... mber_7785/

Phil_Norwich · Post by **Phil_Norwich** » Sat Jun 09, 2012 3:25 pm

Deviant400 wrote: remove the speedo drive from the sproket cover and check the white drive bush that attaches to the sproket nut is not fooked
http://www.davidsilverspares.co.uk/part ... mber_7785/

It was indeed fooked. The link you posted was the drive bush the other day, now its a needle set

I'll get one ordered. Thanks!