how to open nc30 left hand switchgear

[makz2008]

Hi all, my friend has an Nc30 which has a sticky switch,
we cant figure out how to open it up to have a look at the contacts/switches
any advice would be greatly appreciated
thanks
maks

[Man_Named_Dave]

As far as I remember there are 2 screws on the underside and then you kind of crack it open. I'd put a white cloth underneath or similar to catch any bits that go flying.

[makz2008]

ok il have another look,
but i only noticed one screw

[porndoguk]

2 x Phillips screws, about m5/50mm youll need to tuge the upper or lower part to lossen from the bar, there is a retaining lug that sits in the handle bar so dont twist or youll snap it,

The wiring clamps into the upper part but there is wiring for the horn that also goes to the bottom part which makes it hinge off so to speak

Rick

[makz2008]

thanks iv found them going to try getting it off now il let you know how it goes

[Man_Named_Dave]

Be VERY careful if and when you prise the white plastic square out. The little springs and bits of copper are liable to fly anywhere and are a complete bugger to find on the floor!

[scooble]

the high/low beam switch has a sprung ramp arrangement.
Everything stays in its place when you prize the halfs apart though.
Probably best to remove it from the loom and take it indoors. My hi/low was gunged up, but only toggles now if I hit the switch quickly

[iDemonix]

Do it at your own peril, I opened my old semi-working one once, glanced in and decided to give it to Rick for free I believe

[porndoguk]

Do it at your own peril, I opened my old semi-working one once, glanced in and decided to give it to Rick for free I believe

Twaz the case as the writting was all white and nice unlike my nasty faded one,

[makz2008]

havent got around to doing this yet, may have a pop tomorrow so expect some noobish questions