NC30 Honda Britain rep

[Deviant400]

tony i posted up the vid on page 9 of your thread however it is a sp style but it sits a lot lower and sticks out much more ,

[Deviant400]

also what have you done to the frame has it been blasted or owt looks like it and is that a standard chopped subby

[Drunkn Munky]

tony i posted up the vid on page 9 of your thread however it is a sp style but it sits a lot lower and sticks out much more ,

Ah thats the F1 race so a RC30

also what have you done to the frame has it been blasted or owt looks like it and is that a standard chopped subby

Nothing done to the frame just a degrease, the rear subframe is standard and chopped as per the race manual. It was then bead blasted, zinc plated then painted.

[Deviant400]

kool looks very clean i thought it had been beaded or summit , very nice

[Tim400GB]

Looking good mate.
You managed to contact TS yet? And/or Phil?

[Drunkn Munky]

Mo has emailed phil but not got round to contacting TS yet, my bank balance needs to be a bit healthier before commiting to having the motor done. The spare motor is shimmed up and fitted today so its progressing.

[Drunkn Munky]

More shinny bits arrived back and its starting to go together......slowly



I finally got the bastard swingarm needle bearing out for the second time today so once mr silver delivers a new one i shall attempt to fit it without wrecking it again and the rear end can go on with the HRC RS axle :)

[mo haggs]

Putting those sma tins to good use already i see tony.

[Deviant400]

Putting those sma tins to good use already i see tony.

i spotted them

[Drunkn Munky]

Putting those sma tins to good use already i see tony.

There only 6 weeks old and i got loads of the buggers, i'll never be short of storage tins again, just forever short of cash