NC30 Race Bike Wiring?

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
h2o-pro
Settled in member
Posts: 19
Joined: Mon Jan 23, 2012 5:28 am
Location: Queensland, Australia
NC30 Race Bike Wiring?

Post by h2o-pro »

I know this has probably been covered before but I can't find a thread that gives me a definitive answer...My race bike harness had been hacked around so I have stripped it down and got rid of everything I don't need...I have also left it charging... I need to know what do I do with the clutch diode wires? I have no clutch switch & the diode is missing anyway...There is a connector with a green/red & lightgreen/red wire... Can anyone tell me 'politely' what to do with these wires so that I can eliminate this circuit from the harness?
Top
magg
Senior Member
Posts: 1917
Joined: Mon Sep 20, 2010 11:55 pm
Bike owned: VFR400
Location: Blue Mountain NSW Australia
Re: NC30 Race Bike Wiring?

Post by magg »

You need to connect the red/green wire to the chassis to complete the starter solenoid circuit, the light green/red wire will have no function. If you want to remove this wire pair from the loom, connect the red/green wire at the starter solenoid directly to the chassis.
Top
h2o-pro
Settled in member
Posts: 19
Joined: Mon Jan 23, 2012 5:28 am
Location: Queensland, Australia
Re: NC30 Race Bike Wiring?

Post by h2o-pro »

Thanks...that's what I'll do!
Top
Post Reply

Return to “Honda - Workshop”