Front and rear stands

Post by **racingt** » Wed Apr 25, 2012 9:26 pm

Hi guys, are axle stands specific to the rvf or can we use vfr750 stands? Can't be much difference surely?

Post by **CRM** » Thu Apr 26, 2012 7:36 am

RC30 uses the same rear i know that

Mavirick · Post by **Mavirick** » Thu Apr 26, 2012 7:56 am

I would like the answer to this aswell

Ive been looking for a stand for the NC35 bu cant find one but on the other hand there is two RC30 stands available for a rocker of a deal

thanks MAV

Post by **CRM** » Thu Apr 26, 2012 9:08 am

if i recall the hub size is different on the VFR750/800 but like i say i know its the same as the RC30.
i will say though the Abba fitting kits again suit the RC/NC series, and also fit on the CBR600FX too

Post by **hunter** » Thu Apr 26, 2012 10:50 am

I have just bought a rear stand off a guy that he used for his triumph,It does fit my NC hub.
It was a good buy to.Cost me a Fiver.

Forgot to say it was an aftermarket one.

Post by **Deviant400** » Thu Apr 26, 2012 10:58 am

i have a stand made by champion, it has a nylon sleeve that fits on the axle pin that you can swap for different bikes, i had to order a new sleeve for my nc30 , when the sleeve arrived it just said honda on the packet , so i assumed they were all the same fit/size

Front and rear stands

Front and rear stands

Re: Front and rear stands

Re: Front and rear stands

Re: Front and rear stands

Re: Front and rear stands

Re: Front and rear stands