Running nc30 without clocks "or aftermarket clocks"

bean · Post by **bean** » Sat Mar 17, 2012 2:41 pm

As per title guys, my nc30 track bike has a tendency to run fine when on the stand but when it's moving is awful, been all over everything and the only thing I can think of is this bike has a cut original loom and aftermarket tachometer, could this be the issue?, I seem to remember there is a speed restriction built into the ecu/clocks if the clocks are removed does it prevent the engine running while in gear properly?
Is there a quick fix here without buying some clocks?
Cheers
Ben

banoffee · Post by **banoffee** » Sat Mar 17, 2012 3:11 pm

Rick O sells a plug in resistor

bean · Post by **bean** » Sat Mar 17, 2012 3:21 pm

Thanks for the reply chap,, can't seem to find rick Oliver in the approved traders whatnot, do you happen to have a contact number?

Andy666 · Post by **Andy666** » Sat Mar 17, 2012 4:09 pm

bean wrote:Thanks for the reply chap,, can't seem to find rick Oliver in the approved traders whatnot, do you happen to have a contact number?

Here ya go, taken from his price list;

Address;
The Croft
Horning Road
Woodbastwick
Norwich
NR13 6HJ

Tel - +44(0)1603 720387 (5:00 – 9:00 pm)
Email - ricknc30@googlemail.com

Resistor is £6 on there by the way;

http://www.rvf.dk/rickoliver/

bean · Post by **bean** » Sat Mar 17, 2012 9:08 pm

Spoke to rick just a min ago,, top fella!
All sorted I hope, thanks for the help folks

Running nc30 without clocks "or aftermarket clocks"

Running nc30 without clocks "or aftermarket clocks"

Re: Running nc30 without clocks "or aftermarket clocks"

Re: Running nc30 without clocks "or aftermarket clocks"

Re: Running nc30 without clocks "or aftermarket clocks"

Re: Running nc30 without clocks "or aftermarket clocks"