NC35 Swingarm Needle Bearing Install Depth
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
RoninZX-10R
- Settled in member
- Posts: 216
- Joined: Tue Jul 07, 2009 1:50 am
- Bike owned: NC35 racebike, ZX10R roadbike
- Location: Melbourne, Australia
NC35 Swingarm Needle Bearing Install Depth
Hi folks,
I'm in the process of installing new swingarm bearings into my NC35 and noticed in the NC30 workshop manual (I don't have one for the 35) it states that the needle bearing is to be pressed into the left side 4mm in from the edge of the swingarm.
Now, I know the 30 and 35 swingarms differ (I was sent the wrong bearings by mistake...thanks CMSNL Parts Micro Fiche
) so I was hoping someone on here would know if the NC35 needle bearing gets installed to the same depth???
Thanks in advance
I'm in the process of installing new swingarm bearings into my NC35 and noticed in the NC30 workshop manual (I don't have one for the 35) it states that the needle bearing is to be pressed into the left side 4mm in from the edge of the swingarm.
Now, I know the 30 and 35 swingarms differ (I was sent the wrong bearings by mistake...thanks CMSNL Parts Micro Fiche
) so I was hoping someone on here would know if the NC35 needle bearing gets installed to the same depth???Thanks in advance
-
RoninZX-10R
- Settled in member
- Posts: 216
- Joined: Tue Jul 07, 2009 1:50 am
- Bike owned: NC35 racebike, ZX10R roadbike
- Location: Melbourne, Australia
Re: NC35 Swingarm Needle Bearing Install Depth
Surely someone must have replaced bearings in an NC35 swingarm???
Sorry to be pushy but I'l getting them pressed in today, so if I don't get an answer I'm assuming from the workshop diagram that I'll be able to measure the depth of the LHS swingarm pivot, measure the needle bearing, and if the depth is 4mm more than the bearing I'd say it would be safe to assume it's the same as the NC30? How does that sound?
Sorry to be pushy but I'l getting them pressed in today, so if I don't get an answer I'm assuming from the workshop diagram that I'll be able to measure the depth of the LHS swingarm pivot, measure the needle bearing, and if the depth is 4mm more than the bearing I'd say it would be safe to assume it's the same as the NC30? How does that sound?