HRC velocity stacks or not..?

Post by **spanky** » Thu Oct 13, 2011 12:17 pm

Afternoon,

Any HRC experts out there? Trying to work out if my NC35 velocity stacks are HRC or just two sets of standard short ones...

Ta,
James

Post by **CMSMJ1** » Thu Oct 13, 2011 12:46 pm

the odds are they are 2 std short ones.. Not sure I've seen any proper short ones

Post by **spanky** » Thu Oct 13, 2011 1:11 pm

that's what I figure but have failed to find any definitive dimensions anywhere. I think you're probably right though. No ebay fortune for me...

Yakama · Post by **Yakama** » Thu Oct 13, 2011 1:17 pm

I think I have a brand new in the bag set at home, I will try and dig them out and measure them for you

Post by **spanky** » Thu Oct 13, 2011 1:37 pm

Brand new HRC bits just kicking around at home? That's a bit flash.

Yakama · Post by **Yakama** » Thu Oct 13, 2011 1:41 pm

Im a bit of a hoarder. From memory I think the HRC ones are 20mm rather than the standard short ones being 30mm but may be wrong

Post by **CMSMJ1** » Thu Oct 13, 2011 2:17 pm

^^This is what I reckon too^^

Post by **Drunkn Munky** » Thu Oct 13, 2011 4:21 pm

Stanfard are 20mm hrc are 30mm

Post by **spanky** » Thu Oct 13, 2011 4:37 pm

Which makes them standard. Thanks all...

Yakama · Post by **Yakama** » Thu Oct 13, 2011 5:00 pm

Drunkn Munky wrote:Stanfard are 20mm hrc are 30mm

Knew it was something like that