NC30 Carb Needles

Post by **Morespeedvicar** » Sun Sep 11, 2011 6:40 pm

Hi, just giving my bike a bit of service to see why theres a missfire about 7K. Anyway i took slides out to see if the diaphrams were split or anything and the needles dont point straight up, parallel to the side of the slide, they lean towards the little hole in the bottom of the slide. I've ever seen this before, all the carbs i've taken to bits before the needle sits straight to the slide, so i wondering if me slides have worn somehow?

Hope you can see wat i mean?
Thanks
Ian

Post by **Morespeedvicar** » Wed Sep 14, 2011 1:12 am

Anbody have a clue? i dont want to buy more slides if there all like this? Just look wrong tho!
Cheers

Post by **Cammo** » Wed Sep 14, 2011 1:28 am

There's nothing wrong with them Ian, it's typical.

The needles don't sit centrally in the emulsion tubes at high air velocities.

Post by **Neosophist** » Wed Sep 14, 2011 11:50 am

Cammo wrote:There's nothing wrong with them Ian, it's typical.

The needles don't sit centrally in the emulsion tubes at high air velocities.

+1 (It's ok)

Post by **Morespeedvicar** » Thu Sep 15, 2011 1:23 am

Cool, many thanks for the updates, i slam them back together tomorow.
Cheers
Ian

jabawoc · Post by **jabawoc** » Fri Sep 16, 2011 8:18 pm

regarding your misfire check the plugs, I had the same problem at around 7-8k, turned out to be a cracked ceramic on one plug.

Post by **Morespeedvicar** » Mon Sep 19, 2011 1:25 am

Yeah cheers, its in loads a bits so wont hurt to have a look and see.
Thanks.
Ian

NC30 Carb Needles

NC30 Carb Needles

Re: NC30 Carb Needles

Re: NC30 Carb Needles

Re: NC30 Carb Needles

Re: NC30 Carb Needles

Re: NC30 Carb Needles

Re: NC30 Carb Needles