NC29 Race engine project

Post by **Cammo** » Wed Jan 12, 2011 10:19 pm

PARUS wrote:Does anybody know - where is greggo now ?

I think he sold the 400 (it was up for sale) and bought a 675 to race.

Post by **greggo** » Thu Jan 13, 2011 11:21 am

Still got the 400, never did get much interest. Got the 675 but only ridden it 3 times. This year is already looking shakey. First two months of the year and I have Bucks parties, weddings, holidays and other commitments that clash with the start of the seasons racing.

I'll ride both when the opportunities present themselves. But less time in the saddle means I go slower due to my complete lack of any actual talent. Which is just crap.

alexhumber · Post by **alexhumber** » Fri Aug 19, 2011 7:07 pm

That was a SWEET bike. Please repeat!

PARUS · Post by **PARUS** » Sat Aug 20, 2011 6:56 pm

alexhumber wrote:That was a SWEET bike. Please repeat!

I don't think he is very exiting to spend year to build a bike and get it broken in 10 minutes..

Post by **greggo** » Fri Aug 28, 2015 9:24 am

I is back. But with an RVF to play with.

Portlandpike · Post by **Portlandpike** » Tue May 23, 2017 10:01 pm

Hi ya Greggo love the thread shame about the bang fella,I would like to do the same as you but fitting nc30 gearbox output shaft in my nc23 and was wondering who you used to do the work to make it fit also the same again for the people who harden it again for you.
Many thanks Jake

NC29 Race engine project

Re: NC29 Race engine project

Re: NC29 Race engine project

Re: NC29 Race engine project

Re: NC29 Race engine project

Re: NC29 Race engine project

Re: NC29 Race engine project