Twin stack on but funny angle....

Post by **Drunkn Munky** » Wed Jun 29, 2011 10:28 pm

Wernt you the guy that has the full system but didnt want to change the front pipes? if so theres your problem

Post by **Hadies** » Wed Jun 29, 2011 10:29 pm

spadey99 · Post by **spadey99** » Wed Jun 29, 2011 10:31 pm

I think its a Tyga? Asked Gavin if he can sekk me a hanger. When you loosen everything it moves loads so I reckon it just needs a hanger to pull it all together.

spadey99 · Post by **spadey99** » Wed Jun 29, 2011 10:34 pm

Yes I was and you are probably right... Ok tomorrow I will be mostly changing the front pipes..... Lazy bas**rd I know........

amorti · Post by **amorti** » Thu Jun 30, 2011 9:57 am

I daresay that's so far out, that if you pulled it in with a sturdy bracket, you would end up with stress fractures on the downpipes somewhere.

Post by **CMSMJ1** » Thu Jun 30, 2011 10:55 am

Why don't you fit it right? If you are fitting a nice system then you might as well get it spot on rather than nearly.

Loosen the pipes and get jiggling them - it will fit better than that and using a bracket is not going to work long term.

Twin stack on but funny angle....

Re: Twin stack on but funny angle....

Re: Twin stack on but funny angle....

Re: Twin stack on but funny angle....

Re: Twin stack on but funny angle....

Re: Twin stack on but funny angle....

Re: Twin stack on but funny angle....