VFR400 rebuild

Post by **lizard821000** » Fri Jun 17, 2011 12:23 am

http://www.youtube.com/watch?v=22OXvFZI ... detailpage

beautifal

Post by **lizard821000** » Fri Jun 17, 2011 11:05 am

just bought some of these, seemed a fair price tbh....

http://cgi.ebay.co.uk/Honda-VFR400-NC30 ... 27bb5fbc85

Post by **porndoguk** » Fri Jun 17, 2011 11:14 am

lizard821000 wrote:just bought some of these, seemed a fair price tbh....

http://cgi.ebay.co.uk/Honda-VFR400-NC30 ... 27bb5fbc85

ROFL

dude delkevic are taking the piss there,

you can get the same pegs from M&P for £15 + £3 P&P!

there CBR replica/replacement pegs

Post by **lizard821000** » Fri Jun 17, 2011 11:15 am

lol, check out the p&p price rick

Post by **porndoguk** » Fri Jun 17, 2011 11:26 am

lizard821000 wrote:lol, check out the p&p price rick

yeah thats what i meant $200 od for them chuff that, they just cheappy pegs

i got them on my old rear sets

Post by **lizard821000** » Fri Jun 17, 2011 11:55 am

yeah, i bought a set for 15 quid posted bud, same ones :)

Post by **oldgreyandslow** » Fri Jun 17, 2011 9:47 pm

lizard821000 wrote:http://www.youtube.com/watch?v=22OXvFZI ... detailpage

beautifal

Do you think it ever gets used?

It is nice btw but bikes are for riding! IMHO

Post by **lizard821000** » Wed Jun 22, 2011 6:08 pm

bought some of these for my naked forks i bought off the lad on here(which were in fking exellent condition i might add matey!!

) look mint they do

http://cgi.ebay.co.uk/SHOWA-Sticker-Dec ... 19c5d8bfd7

Post by **lizard821000** » Tue Jun 28, 2011 10:31 am

hopefully weekend im gunna stripe down the carbs and clean and inspect, now obviously until i do i dont know wether its gunna need new jets etc or what mods maybe lurking inside them, but is there anything else located in that area thats good to replace and do at the same time?? air filters?? etc. i hate striping down things then haveing to wait weeks for stuff to arrive befor i rebuild them...... iv read that standard my jap import carbs run lean, anything i need befor i do this. i will be using cammos guied of cource

its a RLM

Post by **Drunkn Munky** » Tue Jun 28, 2011 10:45 am

RVF carb rubbers, Makes refitting easier, some red rubber grease also helps
Float bowl gaskets, Cheap so worth getting incase one decides to leak, V annoying when you've put the bike back together.
RO Stainless bolt kit, If the screws are not already chewed up they soon will be

VFR400 rebuild

Re: VFR400 rebuild

Re: VFR400 rebuild

Re: VFR400 rebuild

Re: VFR400 rebuild

Re: VFR400 rebuild

Re: VFR400 rebuild

Re: VFR400 rebuild

Re: VFR400 rebuild

Re: VFR400 rebuild

Re: VFR400 rebuild