NC23 RRJ Bearing sizes..

DK-Tandy · Post by **DK-Tandy** » Tue Jun 21, 2011 10:51 am

im after some bearings and dust seals for my 23..

what are the sizes for
REAR LEFT HAND BEARING
REAR RIGHT HAND BEARING
SPROCKET BEARING

does anyone have the bearing sizes?

Post by **BillingCBR** » Tue Jun 21, 2011 12:51 pm

I'm off out to my mums in 15 minutes, I'll look for the old boxes and I'll text Ricky as I don't have your number. I do only have the wheel bearing numbers not the sprocket carrier one though, as mine looked new when I stripped everything down.

Seals are (2 of) 30X44X5

Post by **BillingCBR** » Tue Jun 21, 2011 2:22 pm

sorted, 2x 6022-2RS and 1x 6222-2RS as far as I can work out

DK-Tandy · Post by **DK-Tandy** » Tue Jun 21, 2011 4:19 pm

do you know the dimensions so i can get some made? Width, diameter etc?

Post by **BillingCBR** » Tue Jun 21, 2011 4:37 pm

get some made? what, the bearings? why go to all the fuss of getting them made when they're an off the shelf part? seals are cheap enough to aswell

DK-Tandy · Post by **DK-Tandy** » Wed Jun 22, 2011 10:50 am

wemoto want just over 30 quid for the parts. Which means its eating the exhaust fund

I have 2 sprocket carrier's so i might not change those bearings depending on they're condition.

Matchlessman · Post by **Matchlessman** » Wed Jun 22, 2011 10:57 am

Best bet would be to change them all now and get the job done. then at least you have peace of mind that they are all replaced.

Post by **CMSMJ1** » Wed Jun 22, 2011 11:45 am

DK-Tandy wrote:wemoto want just over 30 quid for the parts. Which means its eating the exhaust fund

I have 2 sprocket carrier's so i might not change those bearings depending on they're condition.

Don't get them from Wemoto then...

They are generic bearings, look in yell.co.uk for a bearing supplier, call them and ask for some pricing on the codes you have got...job jobbed..

DK-Tandy · Post by **DK-Tandy** » Wed Jun 22, 2011 11:47 pm

i thought the part number would of been honda specific? Or is that the part number in general...

Post by **BillingCBR** » Thu Jun 23, 2011 2:41 am

nope, just a bearing number, so you can say I want 2 of XXX2RS, they can then punch it in and find it straight away.

NC23 RRJ Bearing sizes..

NC23 RRJ Bearing sizes..

Re: NC23 RRJ Bearing sizes..

Re: NC23 RRJ Bearing sizes..

Re: NC23 RRJ Bearing sizes..

Re: NC23 RRJ Bearing sizes..

Re: NC23 RRJ Bearing sizes..

Re: NC23 RRJ Bearing sizes..

Re: NC23 RRJ Bearing sizes..

Re: NC23 RRJ Bearing sizes..

Re: NC23 RRJ Bearing sizes..