nc30 standard exhaust

sheepus7 · Post by **sheepus7** » Thu Jun 02, 2011 3:05 pm

on the standard exhaust can you take the endcan off and put a new slip on one on it

thanks
sean

Post by **porndoguk** » Thu Jun 02, 2011 3:12 pm

sheepus7 wrote:on the standard exhaust can you take the endcan off and put a new slip on one on it

thanks
sean

NO IT NEEDS CUTTING OFF

sheepus7 · Post by **sheepus7** » Thu Jun 02, 2011 3:30 pm

ok thanks
where a bouts do i cut it and will an agle grinder cut it ok
thanks

Post by **porndoguk** » Thu Jun 02, 2011 4:04 pm

sheepus7 wrote:ok thanks
where a bouts do i cut it and will an agle grinder cut it ok
thanks

cut it where ever you want youll need to make or obtain a link pipe for most end/slip on cans,

grinder will do it, but a hacksaw would be much neater.

sheepus7 · Post by **sheepus7** » Thu Jun 02, 2011 4:13 pm

porndoguk wrote:
sheepus7 wrote:ok thanks
where a bouts do i cut it and will an agle grinder cut it ok
thanks
cut it where ever you want youll need to make or obtain a link pipe for most end/slip on cans,

grinder will do it, but a hacksaw would be much neater.

thanks for the advice and what endcan would you recomend

Post by **porndoguk** » Thu Jun 02, 2011 5:09 pm

sheepus7 wrote:
porndoguk wrote:
sheepus7 wrote:ok thanks
where a bouts do i cut it and will an agle grinder cut it ok
thanks
cut it where ever you want youll need to make or obtain a link pipe for most end/slip on cans,

grinder will do it, but a hacksaw would be much neater.
thanks for the advice and what endcan would you recomend

tyga

speak to gav at jap4

sheepus7 · Post by **sheepus7** » Thu Jun 02, 2011 5:24 pm

will do also whats the maggot like as i dont have a silly amount of money for a full system

Post by **porndoguk** » Thu Jun 02, 2011 7:53 pm

sheepus7 wrote:will do also whats the maggot like as i dont have a silly amount of money for a full system

dont do it, theyre silly loud, mines loud and it isnt the tyga maggot!

TJenkos · Post by **TJenkos** » Thu Jun 02, 2011 8:17 pm

I have an oval tyga end can which will be for sale soon if you're interested! I can sell the whole system if you prefer not to butcher up your standard system..

sheepus7 · Post by **sheepus7** » Fri Jun 03, 2011 6:46 am

TJenkos wrote:I have an oval tyga end can which will be for sale soon if you're interested! I can sell the whole system if you prefer not to butcher up your standard system..

how much for the end can and how much for the full system with the endcan