nc35 forks damping screw does not click.

holedigger · Post by **holedigger** » Tue May 10, 2011 9:06 pm

Hi , I'm in need of a bit advice. I have just fitted Rick Oliver upgrade springs and new oil seals and dust seals on nc35 forks I followed the haynes manual for instructions having never done it before .... but when reading through lots of threads on here about setting up the pre load and damping settings , people talk about clicks on the damping screw .Well mine don't click

is there a chance that I may have done something wrong?

Post by **CMSMJ1** » Tue May 10, 2011 9:15 pm

the click is a little ball bearing in the adjuster - either lost or stiff. get the adjuster stripped out and cleaned up

holedigger · Post by **holedigger** » Wed May 11, 2011 5:05 pm

thank you. I'll look into that.

nc35 forks damping screw does not click.

nc35 forks damping screw does not click.

Re: nc35 forks damping screw does not click.

Re: nc35 forks damping screw does not click.