NC30 Ignition Fault
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
lazyboydobby
- Settled in member
- Posts: 39
- Joined: Mon May 10, 2010 12:23 pm
NC30 Ignition Fault
Yesterday i put my NC30 on a rolling road to see what power it had lost over the years.
to my shock it was still putting out 59.5bhp and was drawing a perfectly straight line. The only problem was that this line went to pot when the engine revs went about 10,000rpm. the line became unstable and even skipped. After this dyno wen i was riding it i began to notice what they had said.
The people that did the rolling said that the air/fuel ratios where bang on and it was an iginition fault.
I have only recentley fitted new spark plugs so i presume they are fine. The guy told me to check HT leads, Coils if they was ok then it was the ignition box????
Has anyone else expectianced these symtoms? or can provide assistance in how to sort?
Regards James
to my shock it was still putting out 59.5bhp and was drawing a perfectly straight line. The only problem was that this line went to pot when the engine revs went about 10,000rpm. the line became unstable and even skipped. After this dyno wen i was riding it i began to notice what they had said.
The people that did the rolling said that the air/fuel ratios where bang on and it was an iginition fault.
I have only recentley fitted new spark plugs so i presume they are fine. The guy told me to check HT leads, Coils if they was ok then it was the ignition box????
Has anyone else expectianced these symtoms? or can provide assistance in how to sort?
Regards James
-
Drunkn Munky
- Site Supporter
- Posts: 6313
- Joined: Thu May 01, 2008 9:37 am
- Bike owned: NC30 MC21 TZR FZR GSXR RG MITO
- Location: Kent
Re: NC30 Ignition Fault
Start by doing the common electrical checks described in the haynes manual or in the docs section of this site, then and only then should you bve looking at the CDI. dont think ive ever known one to go tho.
-
lazyboydobby
- Settled in member
- Posts: 39
- Joined: Mon May 10, 2010 12:23 pm
Re: NC30 Ignition Fault
cheer i will try n get round to having alook this weekend and let you know how it goes.
-
lazyboydobby
- Settled in member
- Posts: 39
- Joined: Mon May 10, 2010 12:23 pm
Re: NC30 Ignition Fault
6 months ago, the recifier went taking out some of the wiring loop. i repair the cables. could this have an effect on the perforance. or the stator in the altanator?