hellooo, and a little question if I may...............

dai · Post by **dai** » Fri Aug 08, 2008 4:51 pm

Hello everyone.

there have been some changes since I was here last and I've had to re register, this new place looks good.

anyway, on to the point of this post.

I've just dusted of the NC30 with plans of getting it MOT'd, I've done a load of work to it over the winter including replacing the exhaust, rebuilding the calipers and so on but now one of the bleedin fork seals is leaking

I have a seal here which is 41x54x11, I've been searching the interweb but cant find out if that is the correct dimension for the nc30 or if its an old seal thats left over from a different bike, can anyone help please.

A virtual pint is on offer to the first to answer. :D

Post by **Cammo** » Fri Aug 08, 2008 5:06 pm

Dunno.

Thanks for the pint!

dai · Post by **dai** » Fri Aug 08, 2008 6:13 pm

your welcome

, bit early for you to be drinking isn't it?

dai · Post by **dai** » Thu Aug 14, 2008 4:22 pm

for future reference, 41x54x11 is the correct size.

hellooo, and a little question if I may...............

hellooo, and a little question if I may...............

Re: hellooo, and a little question if I may...............

Re: hellooo, and a little question if I may...............

Re: hellooo, and a little question if I may...............