Is This Fitted Right?

Post by **ChowderV4** » Thu Jan 20, 2011 5:53 pm

end to end its about as wide as a 10pence peice. its probably nothing, its just being left with that after taking apart my linkage scared me slightly.

vfrman · Post by **vfrman** » Thu Jan 20, 2011 8:24 pm

It isn't part of the linkage, and isn't a dowel from the engine either.

Post by **ChowderV4** » Wed Mar 23, 2011 7:20 pm

holy thread revival batman!

i found out where that missing piece goes today :D turns out it was pretty damn important!

alexwitham · Post by **alexwitham** » Wed Mar 23, 2011 7:22 pm

Spill......

Post by **ChowderV4** » Wed Mar 23, 2011 7:38 pm

well i was re-assembling my bike today, and i came to putting the front sprocket cover on and i couldnt get the clutch to engage, the cable was pulling but nothing happening, i was stumped for ages, then i remembered that random bit i was left with.

turns out it fits into the sprocket cover to push the rod in to engage the clutch ( not sure what the "rod" is actually called)

Glad i didnt throw it out, i would have been damn stuck.

Is This Fitted Right?

Re: Is This Fitted Right?

Re: Is This Fitted Right?

Re: Is This Fitted Right?

Re: Is This Fitted Right?

Re: Is This Fitted Right?