NC30 flywheel puller

Sat Jan 15, 2011 1:22 pm

Hi does anyone know the thread dia and pitch of the puller needed to remove the flywheel?
Thanks James

Post by **skinnydog0_0** » Sat Jan 15, 2011 1:59 pm

I just measured mine and it's 20mm x 1.25

Jap pitch

Sat Jan 15, 2011 2:03 pm

skinnydog0_0 wrote:I just measured mine and it's 20mm x 1.25 Jap pitch

Thankyou very much for that

Post by **skinnydog0_0** » Sat Jan 15, 2011 2:07 pm

No problem, have you got a rotor holder for getting the flywheel off?

Sat Jan 15, 2011 2:26 pm

Not yet, im going to try and borrow one from a local bike dealer.

banoffee · Post by **banoffee** » Sat Jan 15, 2011 5:36 pm

whereabouts are you?

Sat Jan 15, 2011 7:06 pm

banoffee wrote:whereabouts are you?

I live in York

banoffee · Post by **banoffee** » Sat Jan 15, 2011 7:59 pm

ah, not close then or you could have borrowed mine (have both). got my puller from Rick Oliver and the holder from ebay (was only about a tenner).

Sat Jan 15, 2011 8:10 pm

Thankyou for the info

hondaprojectnc24 · Post by **hondaprojectnc24** » Thu Oct 22, 2015 8:11 am

Thanks to all for your replies.