Hello All,
My NC23 tends to bog down off the line.
Only happens when up to tempreture and onyl when pulling away from a standstill
Runs fine across the rest of the rev range
Is this a sign of rich or lean on the idle mixture (currently set at 2.5 turns out) or something else?
Cheers,
C
NC23 'BOGGING DOWN'
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
- Site Supporter
- Posts: 629
- Joined: Wed Aug 06, 2008 9:51 pm
Re: NC23 'BOGGING DOWN'
If it gets worse when warm that suggests it's rich.
Blip the throttle from tickover - if the revs hang above idle before returning to idle it's lean, if the revs drop below idle then pick up back to idle it's rich.
Blip the throttle from tickover - if the revs hang above idle before returning to idle it's lean, if the revs drop below idle then pick up back to idle it's rich.
-
- Familiar Member
- Posts: 408
- Joined: Fri Jul 25, 2008 4:36 pm
- Bike owned: Ducati 900SS, 1978 Cafe 400/4
- Location: Trowbridge, Wilts
Re: NC23 'BOGGING DOWN'
My 400/4 did this after a rebuild....
After much headscratching I found one of the sparkplugs had worked loose with the resulting loss of compression.
After much headscratching I found one of the sparkplugs had worked loose with the resulting loss of compression.

-
- Settled in member
- Posts: 56
- Joined: Sun May 02, 2010 8:07 pm
Re: NC23 'BOGGING DOWN'
Revs seem to level out straight away no floating or dipping but my guess is running rich as it gets worse the hotter the bike becomes.
Will check the plugs before adjusting the mixture.
Thanks for your help.
Will check the plugs before adjusting the mixture.
Thanks for your help.
-
- Site Supporter
- Posts: 422
- Joined: Thu Jul 15, 2010 12:59 pm
- Bike owned: NC23 NC30 CRM250
- Location: West Midlands
Re: NC23 'BOGGING DOWN'
Mine does exactly this, in fact if i just try to move off normally it bogs down and will die.
if i just slowly turn accelerator to make the revs build slowly it is fine.
Its as if, blipping the throttle makes it die. Not a great help in traffic.
Did you sort what it was for your bike?
if i just slowly turn accelerator to make the revs build slowly it is fine.
Its as if, blipping the throttle makes it die. Not a great help in traffic.
Did you sort what it was for your bike?
-
- Settled in member
- Posts: 56
- Joined: Sun May 02, 2010 8:07 pm
Re: NC23 'BOGGING DOWN'
Mine was a Fueling issue, leaning in the Idle helped but it's still not perfect, could be coils or ht leads struggling at low revs or plugs perhaps