Drilling Slide Advice / Pilot Screw Query.

[Neosophist]

Does anyone know which NC24 carb slides have the curved bottom mentioned above as there are two different part numbers according to microfiche:

16111-ML0-724 & 16111-ML-0004

cheers

724 are a later revision and probably the only ones about.. there was a full set of brand new ones on ebay recently :O

Are you planning to order new ones as there 115 each IF you can get them 460 is awfully expensive.

[superlite]

I`ve managed to get my hands on some NC30 carbs which have HRC slides and springs in them.Rick

After eagerly putting my hand up for some HRC slide springs, I realised that HRC don't have a part listed for slide springs for the NC30? At least, I can't find any part numbers? Am I dreaming here? I've had some very dodgy springs in HRC equipped carbs in the past - are the springs you have the the real deal Rick Please say yes

[Yakama]

Does anyone know which NC24 carb slides have the curved bottom mentioned above as there are two different part numbers according to microfiche:

16111-ML0-724 & 16111-ML-0004

cheers

724 are a later revision and probably the only ones about.. there was a full set of brand new ones on ebay recently :O

Are you planning to order new ones as there 115 each IF you can get them 460 is awfully expensive.

I just want to know to see if I can source any cheap ones and also to see if its the early ones or later ones that are like the HRC slides.

Cheers

[Neosophist]

They should be both the same.. 724 means a revision over the base part, so not sure what was changed.

I'll have a look in the parts book later on see what it says.

[Yakama]

cheers