Factory Pro Jet Kit

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
GCD
Settled in member
Posts: 31
Joined: Tue Aug 24, 2010 7:58 am
Factory Pro Jet Kit

Post by GCD »

Has anyone installed a factory pro jet kit. I just put one in but the NC30 is now running like crap! After reading the factory pro website I think is is running too rich. I have put the 118 jets in the rear carbs and the 115 jets in the front carbs.

Any suggestions to the jet sizes and needle settings I should try?
Top
User avatar
Cammo
Site Supporter
Site Supporter
Posts: 4505
Joined: Thu May 01, 2008 12:35 am
Bike owned: NC30
Location: Melbourne, Australia
Re: Factory Pro Jet Kit

Post by Cammo »

They don't have a good reputation for nc30's - for good reason!
"It's just a ride" Bill Hicks
Top
GCD
Settled in member
Posts: 31
Joined: Tue Aug 24, 2010 7:58 am
Re: Factory Pro Jet Kit

Post by GCD »

So is the suggestion that I return it to standard? Or should I give the smaller 112 jets a go?
Top
User avatar
banoffee
Site Supporter
Site Supporter
Posts: 1247
Joined: Sat Aug 01, 2009 7:44 am
Location: Surrey
Contact:
Contact banoffee
Re: Factory Pro Jet Kit

Post by banoffee »

dyno run? :whistle:
attention 2 detail - bike valeting and more
Top
User avatar
Cammo
Site Supporter
Site Supporter
Posts: 4505
Joined: Thu May 01, 2008 12:35 am
Bike owned: NC30
Location: Melbourne, Australia
Re: Factory Pro Jet Kit

Post by Cammo »

GCD wrote:So is the suggestion that I return it to standard? Or should I give the smaller 112 jets a go?
Dunno, but The Guru (Rick Oliver) has stated that they don't work well in nc's.

This man is the word...

A modified standard setup would probably perfom better, even better is Rick O's aftermarket road needles. :peace:
"It's just a ride" Bill Hicks
Top
Post Reply

Return to “Honda - Workshop”