ok, many thanks again guys for the input.
Seems like i will have to have a look at the carbs. So ill have to do a bit of research here to find out what im looking for.
No i just need to find the tie to do it between now and late May when i have my next track day lined up.
Any other Sydney based Aussies heading to Eastern Creek in late May?
NC35 track bike dieing at end of session
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
[STU]
- Settled in member
- Posts: 9
- Joined: Wed Dec 30, 2009 11:27 pm
-
Cammo
- Site Supporter
- Posts: 4505
- Joined: Thu May 01, 2008 12:35 am
- Bike owned: NC30
- Location: Melbourne, Australia
Re: NC35 track bike dieing at end of session
Stu, the culprit might be something as simple as the pilot screws being incorrectly adjusted (they should be set at 1 + 5/8 turns out for your setup).
Using HRC emulsion tubes might also help your symptoms, but check the PS setting first.
Using HRC emulsion tubes might also help your symptoms, but check the PS setting first.
"It's just a ride" Bill Hicks
-
[STU]
- Settled in member
- Posts: 9
- Joined: Wed Dec 30, 2009 11:27 pm
Re: NC35 track bike dieing at end of session
Thanks mate, ill give it a shot as soon as i can.DataRacer wrote:Stu, the culprit might be something as simple as the pilot screws being incorrectly adjusted (they should be set at 1 + 5/8 turns out for your setup).
Using HRC emulsion tubes might also help your symptoms, but check the PS setting first.
Appreciate the input.
Stu