HELP!!! Before i kill my dad!!!!

[Drunkn Munky]

large torx bit, gentle tap, unscrew, done.

This works

[fixer]

When replacing plugs i push ashort piece of rubber tube over electrode end,with ashort piece of wood doweling in hose end.Locate in plug hole and turn in plug,any tight resistance would be taken up by the rubber hose so avoiding a crossed thread.Hope this is of help.

[richhemmings]

When replacing plugs i push ashort piece of rubber tube over electrode end,with ashort piece of wood doweling in hose end.Locate in plug hole and turn in plug,any tight resistance would be taken up by the rubber hose so avoiding a crossed thread.Hope this is of help.

? I dont get?
rubber tube over the threaded end?

I've always thought screwing plug in by hand was best, then just nipping them up with a wrench / screwdriver with socket?
I use the 13mm socket with an extender bar for my NC30 as the heads are well recessed, also, if you can get tehm, or make one up, my ol' man use to use a socket with a rubber or foam insert to hold the lug strraight - makes lining it up easier.

[fixer]

Oops my mistake other end

[Chris 91UK]

PANIC OVER!!

the whole plug is now out!

stud extractor,,,,nice and slowly, came straight out in about two minutes which surprised me

so now i can talk to the old man again ( but it will be a while before he goes near the bike though!)

thanks very much for the advice greybikers,much appreciated

[w00dzy]

Good stuff, bet that was a relief!