Float Height Adjustment

madmike · Post by **madmike** » Mon Jan 11, 2010 10:01 pm

Moving on from my previous thread.... on a CBR400RR (NC29)

Do you have to source the new float needles and other parts if the float height needs adjusting or... Can they just be adjusted by bending?

madmike · Post by **madmike** » Thu Jan 14, 2010 2:25 pm

bump

Post by **CMSMJ1** » Thu Jan 14, 2010 2:44 pm

Bend them dude...carefully

madmike · Post by **madmike** » Thu Jan 14, 2010 6:36 pm

Thank you!

Post by **Davez29** » Thu Jan 14, 2010 7:03 pm

The floats are all one piece plastic on my bike. Would the plastic tabs on the floats stop where you put them? I would be wary of trying to bend them, perhaps source a spare first just in case. Have you checked the float height adjustment and if so how far is it out?

atheos_mb · Post by **atheos_mb** » Sat Jan 30, 2010 6:54 pm

According to haynes manual the nc29s need replacing where the nc23s can take a bend

Float Height Adjustment

Float Height Adjustment

Re: Float Height Adjustment

Re: Float Height Adjustment

Re: Float Height Adjustment

Re: Float Height Adjustment

Re: Float Height Adjustment